Nokia 2730 USB Connector Problem Repair Guide

Have a problem with your Nokia 2730 USB connector? With this picture guide, you can solve your Nokia 2730 USB problem.

Before you change Nokia 2730 USB driver, check the connector pin first.

Nokia 2730 MMC Problem Repair Guide

As a data storage, memory card or MMC's role is very important. In this post, mobile phone repair will share the tricks to repair damaged phones can't read MMC. MMC is not legible can be caused by a damaged connector, the path is broken, and a damaged driver. In the picture help this time, mobile phone repair will share a tips to fix MMC problem on the Nokia 2730.

  

Happy repair your Nokia 2730 mmc problem.

Nokia 2730 Local Mode | Test Mode Repair Guide

Although very rare, damage to local mode or test mode on the Nokia 2730 can be repaired by removing a capacitor. The location of the capacitor is near the battery connector. If you find a test mode or local mode on the Nokia 2730, please follow the following guidelines pictures.

Nokia 2730 Keypad Problem Repair Guide

Keypad problems often occur when the phone fell into the water. This damage could be due to a short path or even broken. Similarly, Nokia 2730 keypad. The following picture show you location of the Nokia 2730 keypad IC.

Before deciding to replace the IC, you should do checks every path. You can see the Nokia 2730 schematic diagram. If all paths determined in good condition, then you can replace the Nokia 2730 keypad IC.

Nokia 2330 Classic Blinking | Restart Problem Repair Guide

Nokia 2330c is a Nokia mobile phone belonging to the category of DCT-4. Problem that often occur on the Nokia 2330 classic is restarting, blinking, hangs. All the problems were mostly caused by a disruption in phone software. To fix it, we can do the flashing.

To do the flashing on Nokia phones, we can use UFS HWK or MX-Key. However, there is one thing that must be considered by the phone technicians that the problem of software on Nokia 2330c is different from other Nokia phones. Several times I found the Nokia 2330c case of damage, the phone can be detected by the flasher box, but when flashing process is running, suddenly stopped in the middle of flashing process. The result of course be a total dead cell phone. For those of you who use the MX-Key, usually when the flashing process took place, when the erase process, will occur repeatedly.

The solution to this problem is, you must first remove the phone firmware, then you do the flashing again. I have proved this and succeeded. Good luck.